GEO-FIX® ALL WEATHER
Ready to use self-setting permanent joint filler for use in both dry and wet conditions
Geo-Fix® All Weather is ready mixed and can simply be brushed into joints with minimal effort compared to using traditional mortar.
It is easily finished by compacting with a pointing tool saving valuable time compared to traditional wet pointing.
Geo-Fix® All Weather offers huge time saving benefits compared to applying traditional mortar.
Unlike mortar joints, it is totally resistant to freeze-thaw cycles and will not crack or pop out with frost.
Geo-Fix® All Weather forms a solid joint that resists weed and plant growth yet is water permeable, allowing water to escape to prevent ponding.
Works in all weather conditions
Simply brush into joints and compact
Ready to use – no mixing
Sets hard, won’t crack or wash out
Resists weed and plant growth
Totally weatherproof – unaffected by frost
For all joints over 5mm width and minimum 15mm depth
Water permeable, allows water escape
Approx. 15m2 joint width 6 mm x 15 mm joint depth – 450 mm x 450 mm paving units
GEO-FIX® is a quick and easy way of applying a rigid joint on all types of paving having widths of 5mm and over: Indian Stone, ¬ Concrete, ¬ Slate, ¬ Clay, ¬ Terracotta and¬ Granite.
Wet the paving surface. The paving must be kept wet during application but free from standing pools of water. Failure to wet the paving surface will result in temporary staining. Ensure that the areas where you are not working remain wet at all times. This is particularity important in warm or hot weather. Carefully open the vacuum-packed bag and sprinkle GEO-FIX® All Weather sufficient to cover an area of 2-3 m2 Using a soft brush, push the GEO-FIX® All Weather into the joints ensuring that they are filled with the compound. The material MUST be compacted into the joints.
Compact GEO-FIX® All Weather into the joints with a pointing tool or by use of a vibrating plate. Top up and compact ensuring a fully compacted and topped up joint before carefully sweeping off any excess with a soft brush ensuring that the material is swept at a 45° angle to the joints. Finish the surface decoratively giving a smooth flat finish with a pointing tool before moving onto the next area to be jointed Any residue left on the surface when cured can be simply cleaned off by sweeping with a stiff brush. Material or residue that has been left exposed for more than 30 minutes should NOT be used, as it will be adversely affected.
Do not use on joints narrower than 5mm.
Do not use on joints less than 15mm deep.
Do not use on chamfered/tapered joints.